LED underwater light, is mounted on the bottom, a simple means is installed under the bottom of the lamp, small and exquisite, elegant appearance, appearance is similar to some buried lights, more than just a installation chassis, the chassis is screwed.
Because LED underwater light is used below the bottom, need to absorb a certain amount of pressure, so usually adopt stainless steel material, 8-10 mm toughened glass, high quality waterproof connector, silicon rubber sealing ring, arc angles of refraction strengthened glass, waterproof, dustproof, prevent leakage and corrosion.
LED underwater light for LED light source, commonly known as the fourth generation of lighting source or green light source, energy saving, environmental protection, long life, small volume, etc.Electricity, it can send out a variety of colors, colorful, usually in a park or fountain pool. Led Underwater Light,Waterproof Led Underwater Light,Led Mini Underwater Pool Light,Mini Led Underwater Light NINGBO ZHENHAI BOLANG METAL PRODUCT FACTORY , https://www.aldiecastings.com
Self-priming pump casing and pump cover installation method
1, rear-door self - priming pump casing and pump cover installation method
Work can be divided into two steps, the first step is to install the pump housing on the base; the second step is to self-priming pump rotor, pump cover, pump and other components into the pump casing assembly, and then the whole installation On the base
Assembly is the key to ensure that the impeller in the normal working position. Relying on the pump cover and the pump body with the surface to ensure that the impeller population and the seal ring on the pump body coaxiality between the pump body and the seal gasket gasket and adjust the impeller axial position of the dual role. Installation, should be installed on the gasket, and then along the axial impeller together with the pump cover pushed to the pump body, tighten the pump cover bolts, while screwing the disk drive shaft, pay attention to the impeller and the seal ring have no rub, if so, Should be promptly adjusted.
Gaskets can be made of rubber or rubber asbestos and other materials. After adjusting the gap between the ministries, you can bolt the pump cover and the pump housing together.